New Solutions for Ducati, Husqvarna, and KTM
Version 7.9.0.0 of Flex Out Now with new Solutions for Ducati, Husqvarna, and KTM
Download the latest version of Flex and program Continental M4C engine units in OBD Full, Bench, and Boot, enjoy the new solutions for Ducati, Husqvarna, and KTM.
These protocols allow you to read and write the whole content of the Flash memory, with virtualized EEPROM: you can now restore damaged units, writing the backup from a source unit to a destination unit in function.
Thanks to the newest release of Magicmotorsport (version 7.9.0.0), the list of motorcycles supported by Flex becomes more and more numerous, and as of today you can even modify performance of vehicles such as Ducati Hypermotard 950, Husqvarna TC250, and KTM SX 300.
Optimize engine parameters and get the best out of your two-wheel vehicle.
*Please note: for the OBD Full mode, you need to use the dedicated FLX2.68 cable.
Some of the supported vehicles:
- Ducati Hypermotard 950cc 115PS
- Ducati Scrambler 800cc 73PS
- Husqvarna TC 125cc 38PS
- Husqvarna TC 250cc 54PS
- KTM SX 125cc 16PS
- KTM XC 57PS
This new protocol is available for the following software packages:
OBD Full/Bench
- FLS0.1M – SW Flex ECU (car, van, bike) OBD Full/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD Full/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.13M – SW Flex Bikes OBD Full/Bench/Boot Master
- FLS0.13S – SW Flex Bikes OBD Full/Bench/Boot Slave
Boot
- FLS0.4M – SW Flex Boot Nexus MPC5xxx Master
- FLS0.4S – SW Flex Boot Nexus MPC5xxx Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.13M – SW Flex Bikes OBD Full/Bench/Boot Master
- FLS0.13S – SW Flex Bikes OBD Full/Bench/Boot Slave
Newly added protocols:
(OBD Full e Bench)
- Ducati Continental M4C SPC563M Read/Write/Checksum Calculation Internal Flash (EEPROM virtualized), Clone/Restore
Reading Time : ~ 40 seconds Writing Time : ~ 1 minute
(Boot)
- Ducati Continental M4C SPC563M Read/Write/Checksum Calculation Internal Flash (EEPROM virtualized), Clone/Restore
Reading Time : ~ 30 seconds Writing Time : ~ 40 seconds
